Claytons Belly Skid pic!

[ArloGuthroJeep]

It is a skid plate...how complicated of a thing are you expecting?

[zj95]

[faststang1]

Thats sick.....I getting it when I get my claytons!!!!!

[faststang1]

Thats f*** Sick.....I'm getting it, when I get my claytons!!!!!

[5.9 ANDY]

i agree..... bud did you have to say it twice?

[Jim311]

Cool, thanks for posting that.

[nierace]

Thats pretty sweet.

[SirFuego]

So this has been out for a while now. How is it holding up for everyone?

Mine I guess technically hasn't "failed", but it is bowed pretty good to where it offers less than a finger's width between the skid and tcase. I personally think it needs a bit of reinforcement because of how big it is. Curious if anyone else has run into this problem and if they have reinforced it...

[jsteves]

So this has been out for a while now. How is it holding up for everyone?

Mine I guess technically hasn't "failed", but it is bowed pretty good to where it offers less than a finger's width between the skid and tcase. I personally think it needs a bit of reinforcement because of how big it is. Curious if anyone else has run into this problem and if they have reinforced it...

That is the biggest problem I have with the one I built as well. I built it out of 1/4 and wish I had reinforced it or used thicker steel. I bent it so bad it was touching the t-case.

[ArloGuthroJeep]

Mine is 1/4" but it also has 2"x2"x1/4" angle iron supporting it, widest unsupported part is ~7-8" probably. No bending